Pinellas County PLUS

The traffic signal at the intersection of Tampa Rd & 15th St doesn't give a green arrow allowing traffic to turn left from SB 15th St onto EB Tampa Rd when the crosswalk button for crossing Tampa Rd is pushed, even though the only crosswalk for crossing Tampa Rd at the intersection is on the West side of the intersection and is not affected by traffic turning left onto EB Tampa Rd The crosswalk signal there causes red lights for ALL TRAFFIC IN ALL DIRECTIONS for the entire duration of the walk signal & the flashing don't walk signal Can the traffic light be reprogrammed to give the left green arrow?

It takes 2 min for it to recognize were even and then get stuck at Bryan dairy rd. and belcher for another almost 2 min.This is an
constant problem .The sensor long delay by the time it change
people are falling asleep and on Bryan dairy road and belcher both direction is backing up three or four blocks Making it hard to even get out after waiting 3 min.

The signal timing seems to be off. The signal turns green and only lasts about 8 seconds traveling north on 137th/Oakhurst Rd. Most times does not allow enough time for all traffic to clear the intersection.

The light to turn left onto Dr. Kiran C. Patel BLVD (Nova Southeastern University) takes roughly 8-10 minutes to change from red to green. Traffic flow from both lanes continues to move through several light cycles before left lane turns green. Holds up traffic in turning lane, and can create possibility of an automobile accident if someone in turning lane decides to turn left before the light turns green.

light at 83rd and park blvd is out of sync only 3 or 4 cars can get through.

Pedestrian crosswalk pavement markings are needed/missing eastbound Park Blvd at 104th Lane in Seminole.
There are crosswalk buttons and crosswalk lights, but no crosswalk pavement markings.

Turn signal for traffic going west down west bay and wanting to turn south onto Clearwater largo rd gets maybe 3 cars through the signal before changing. This is between 320-335pm when traffic trying to get child from school. It wasn't this way a few weeks ago but something has changed and I have sat through 2 LONG cycles of lights instead of being able to do one in the past. Please resolve this issue.

Something happened to the light during morning Rush hour. The signals are malfunctioning and instead of waiting 2 minutes to get through it's now taking 15 minutes with the traffic isvbacked up for 2 mikes going South.

I travel East on Lakeview Mon.-Sat. between 3-5AM., and the light at Lakeview and Highland is on a timer, instead of being triggered by cars.
From my experiences over the past 25 years, Lakeview has more traffic, so it should be the dominant light.
But instead, the light is forever green for Highland.
Then about every 30 seconds it will turn green for Lakeview, for approximately 2 SECONDS...!

As a bonus, the light at Keene and Nursery is also on a timer, which it shouldn't be.
Keene has far more traffic than Nursery, but the light changes regardless, and stays red forever.

The signal on Ulmerton and 119 is changing to red for absolutely no reason There is nobody on 119 and it changes red for Ulmerton people This is a big annoyance for folks Please fix the sensors

Traffic light timing has changed at this location Curlew and Belcher.

Previously traffic flow was good traveling south on Belcher at this location. Now it is backed up all the way up Belcher.

Please inspect the timing and adjust to previous timing if possible.